În curs de procesare...

Ecranele touchscreen, capacitive vs resistive

  Resistive touchscreen Capacitive touchscreen
Visibility indoors Typically very good Typically very good
Visibility in sunlight Typically poor, the extra layer reflects too much ambient light. Typically very good.
Touch Sensitivity Pressure is needed to make the contact within the screen's layers, can be affected with fingers (even with gloves on), fingernails, stylus, etc. The latter is important in Asian markets and anywhere where gesture or character recognition is important. Even the slightest contact of your electron-rich finger with the screen's glass is enough to activate the capacitive sensing system below. Doesn't work with inanimate objects/fingernails/gloved fingers. Handwriting recognition is therefore cumbersome.
Accuracy Accurate to at least display pixel resolution, as can be seen when drawing (or writing characters) with a stylus. Useful for handwriting recognition and interfaces with smaller control elements. Accurate to within a few pixels, in theory, but seriously limited by the physical size of your fingertips, which make it hard to accurately press any control element or select something on screen that's smaller than 1cm2.
Cost Cheap to use in a phone design. Definitely more expensive than resistive screens, by between 10% and 50%, depending on who you talk to. On a flagship device, the extra build cost isn't that important, for a mid-priced phone, using a capacitive screen might be prohibitive.
Possibility for multi-touch None, without re-engineering the way a resistive screen is wired into a device's electronics. Depends on implementation and software, but used in the iPhone and tech-demoed on the HTC-made G1. Also may be legal battles with Apple, depending on how multi-touch is used?
Robustness The very nature of resistive screens means that their top layer is soft, soft enough to press down and indent. This makes such a screen vulnerable to scratches and other minor damage. A resistive screen also gradually wears out and requires more frequent calibration. Glass can be used as the outer layer. Although not invulnerable (and certainly prone to shattering on major impact), glass is more resistant to casual scratches and blemishes.
On the plus side, a resistive layer over a plastic screen does make for a device that's generally robust and unlikely to be damaged by a fall.
Hygiene Because a stylus or fingernail can be used to effect each touch, there's a potential for less fingerprints, finger grease and germs to be transferred to the screen. Full finger touch is needed on the screen, but the use of glass as the main material means that the screen's also very quick and easy to clean.
Environmental concerns Nokia has stated that the Nokia 5800, like all their phones, will work happily between -15°C and +55°C and at all real world humidities. Typical operating temperature is 0° to 35°, requires at least 5% humidity (for capacitive effect to work)



Nici o postare găsită

Postare nouă

Tastați caracterele pe care le vedeți în imaginea de mai jos.